Isspro R6326 Bedienungsanleitung PDF herunterladen

ISSPRO, INC. 2515 N.E. Riverside Way, Portland OR 97211

Telephone: (503) 288-4488  Toll Free: (800) 888-8065

FAX: (503) 249-2999

Form 411A (Rev B 9/17/03) Page 1 of 2

ISSPRO R6326 2-Level Temperature Switch

Order Information:

Type K Thermocouple Date Code:

Deg. F lamp Output Trip Point OR Type J Thermocouple

Deg. F Relay Output Trip Point

General Information:

Operating Voltage: 10-16 VDC, Negative Ground Only

Relay Output: Normally open (N/O), Normally closed (N/C), and Common (COM)

Switch Point Hysteresis: Output turns off approximately 25°F below trip point

Maximum Current/Voltage Rating:

Relay Rating: 2 amps @ 24 VDC resistive

0.5 amp @ 24 VDC inductive (Coil Load)

Lamp Output: 0.5 amp max/12VDC

Reverse Voltage Protection: -400 VDC

Adjusting the Trip Points:

Experimentation is not advised. Trip points are set at the factory to custom settings. A

Pyrometer must be installed to adjust properly.

Connecting to an Existing System:

The unit can be connected to a thermocouple which is already installed for an analog

(needle type) pyrometer by installing a separate leadwire for this unit from the

thermocouple.

If the existing pyrometer is a digital type, a second leadwire is not necessary. Connect

this unit to they pyrometer leadwire connections.

1 2

ISSPRO, INC. 2515 N.E. Riverside Way, Portland OR 97211 Telephone: (503) 288-4488  Toll Free: (800) 888-8065 FAX: (503) 249-2999 Form 411A (Rev B

Form 411A (Rev B 9/17/03) Page 2 of 2 Installation Diagram ISSPRO Two-Level Temperature Alarm ThermocoupleLeadwireRedYellowLeadwire to analog pyrom

Keine Kommentare

Isspro R6326 Bedienungsanleitung