Isspro R8510 Bedienungsanleitung PDF herunterladen

ISSPRO, INC. 2515 N.E. Riverside Way, Portland OR 97211

Telephone: (503) 288-4488  Toll Free: (800) 888-8065

FAX: (503) 249-2999

Form No. IS011 (1/10/00 Rev. B) Page 1 of 2

ISSPRO 2” Dia. Ignition Tachometers

P/N R8508 (4k scale), R8509 (5k scale), R8510 (6k scale)

General Information:

Operating Voltage: 10-16 VDC

Reverse Voltage Protected

Calibration:

ISSPRO ignition tachs are pre-calibrated for 4, 6 or 8 cylinder, single ignition coil en-

gines. To se the tach for your particular engine, remove the plastic hole plug (in the rear

of the tach – lower right) and place the jumper in the position corresponding to the

number of cylinders of the engine. The cylinder number is marked on the circuit board.

Installation:

1. Set the tach to the proper number of cylinders as described above.

2. Mount the tach in the desired position.

3. Connect the wires as shown in the wiring diagram. NOTE: The white wire may also be

connected to the “TACH” connection of the distributor, if this connection is available.

1 2

ISSPRO, INC. 2515 N.E. Riverside Way, Portland OR 97211 Telephone: (503) 288-4488  Toll Free: (800) 888-8065 FAX: (503) 249-2999 Form No. IS011 (

Seite 2

Form No. IS011 (1/10/00 Rev. B) Page 2 of 2

Verwandte Modelle: R8509 | R8508 |

Keine Kommentare