Isspro R11289 Bedienungsanleitung PDF herunterladen

Form No. IS175 (Rev. H 06/10/2013)

ISSPRO, INC.

•

2515 N.E. Riverside Way

•

Post Office Box 11177

•

Portland, Oregon 97211-1899

503-528-3400

•

800-888-8065

•

Fax: 503-528-3495

FUEL RAIL PRESSURE GAUGE AND WIRE

HARNESS INSTALLATION INSTRUCTIONS





Disconnect batteries. Do not reconnect battery power until

system is fully configured to avoid risk of shock or fire.

I C O N K E Y

 CAUTION

 Tools may be required

 Shown in picture

Find the factory Rail Pressure sensor and disconnect its harness

connector. For locations on some specific vehicles see section 10 below.

Route the ISSPRO Rail Pressure harness up to the Rail Pressure sensor. One end of the ISSPRO

Rail Pressure Harness will have a connector similar to the one you just unplugged from the Rail

Pressure sensor. Plug this connector into the Rail Pressure sensor, and plug the truck harness

connector (which you disconnected in step #2) into the remaining connection on the Rail Pressure

harness. Be sure on both harness connections that the connector with the latch is oriented so that

its latch engages the angled block on the mating connector, not the non-angled block on the other

side of the connector.

Figure 1: Wrong Direction Correct Direction

 The Rail Pressure sensor is critical to engine operation. If the harness is connected incorrectly

or wire insulation is damaged and sensor wires are shorted out, engine damage can result. Retain

and protect all wiring.

If installing other items that connect to the Rail Pressure sensor, such as a power-adding module,

connect the ISSPRO Rail Pressure Harness directly to the Rail Pressure sensor, then connect the

power module's harness between the ISSPRO harness and the truck harness.

Route the separate black & green wires of the sensor harness to the intended gauge mounting

location, using grommets as appropriate when passing through the firewall.



 Trim the sensor harness wires to length, leaving enough length to allow the gauge to be

pulled from the pod or mounting location without disconnecting the connector.

1 2

Inhaltsverzeichnis

Seite 1

Form No. IS175 (Rev. H 06/10/2013) ISSPRO, INC. • 2515 N.E. Riverside Way • Post Office Box 11177 • Portland, Oregon 97211-1899 503-528-3400 • 800-88

Seite 2

Form No. IS175 (Rev. H 06/10/2013) ISSPRO, INC. • 2515 N.E. Riverside Way • Post Office Box 11177 • Portland, Oregon 97211-1899 503-528-3400 • 800-88

Kommentare zu diesen Handbüchern

Keine Kommentare

Isspro R11289 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Sensoren Isspro R11289 herunter. ISSPRO R11289 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sensoren Isspro R11289